Elenco Electronics rc snap rover Instrucciones de operaciones Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 48
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
-15-
Project #5
OBJECTIVE: To make sounds electronically.
Simple Sounds
OBJECTIVE: To make sounds electronically.
Not So Simple SoundsProject #6
Build the circuit with the base grid
centered on the Rover body, and
connect the jumper wires as shown.
Turn on the slide switch (S1). The
recorded message may play, followed
by a tone. Turn the lower knob on the
sound & recording IC (U9) to adjust
the pitch (frequency) of the tone.
ROVER REAR
Turn knob
to adjust pitch.
Build the circuit with the base grid
centered on the Rover body, and
connect the jumper wires as shown.
Turn on the slide switch (S1). The
recorded message may play, followed
by a tone. Turn the knobs on the
sound & recording IC (U9) to adjust
the sound.
ROVER REAR
Turn knobs
to adjust sound.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Comentarios a estos manuales

Sin comentarios